+86-0371-69191685 |sales@zz-modern.com
News
The steps and methods of repairing the electric boat - 2017-04-14 16:24:06

The steps and methods of repairing the electric boat

1.The damaged surface must be clean and dry.

2.Using angle grinder or sand cloth polish damaged or the need to bond the rough, not

excessive grinding, the grinding surface is larger than that of damaged surface.

3. according to the grinding surface of cut glass fiber cloth, cloth six to eight layers

of muslin two layers should be pasted cloth after pasting cloth.
4, blending resin: resin:

red material: white material = 100:1:2 is the basic proportion, winter can be big, summer

can be smaller, factories in the resin factory prior to red material preparation, use only

to the white material, resin prepared, should be used immediately, otherwise it will be

the solid melt, so with glue, should be fully prepared, can be carried out in accordance

with the introduction of the 1, 2, 3, 4.

5.first on the polished surface of the brush glue, and then paste the two layers of cloth,

continue to brush the glue to the cloth all wet and then stick to the two layer, until the

up to cloth layer.

6.Drying witn  no rain 12-24 hours as well, and then can be used in the water.

7. There have a variety of liquid chemicals,has a slight burn force to skin, try to avoid

direct touch.